The more extensive boards are normally around 10 wide while the little sheets or batten are more like two inches wide.
How far apart board and batten siding.
Centering the fasteners allows the boards to expand and contract without bowing or splitting see diagram below.
The spacing in between the boards should be at least 1 4 for movement of the boards but make the gap such a width that you can nail the batten through the space to prevent splitting the board edges.
One by eight inch boards are very efficient as one board can be torn right into 3 strips of approximately 2 5 to make use of as battens.
In my case the studs were 16 apart and the board spacing edge to edge was 10 1 2 so i used that.
Secure these boards using fasteners fasteners placed at the center of the siding boards.
Board and batten or board and batten siding describes a type of exterior siding or interior paneling that has alternating wide boards and narrow wooden strips called battens the boards are usually but not always 1 foot wide.
Even though i was hitting studs i made sure to double check before i installed.
Houzz experts we are building a small rental property and are putting hardie plank board and batten siding on.
Attach your first batten to the end of the wall.
The boards may be placed horizontally or vertically.
You can vary the board and also batten widths or there are many other variants on this theme.
Basically board and batten siding is a progression of substituting vertical or flat boards.
Now you are ready to install the siding boards.
He says the battens will go at the seam of the panels and then two to split the panels so they are on a 16 center to.
Now measure from the edge of the batten 20 4 and mark that will be the beginning edge of your next batten.
The battens are usually but not always about 1 2 inch wide.
For instance if you are installing 1x10 boards that are 9 3 8 inches wide measure to be sure because they can vary in width with a 5 8 inch gap figure 10 inches for each board.
Which leaves you with a spacing of 20 4 so just under 20 1 2 between each batten this is the exact spacing between each batten.
Our contractor got 4 x 10 panels for the board and 2 1 2 battens.
Measure and mark the spacing center to center for each board check for level using a torpedo level and attach using 2 finish nails and a nail gun.