How Do You Use A Finishing Strip In Vinyl Siding

Once it is in place test by sliding the last piece back and forth slightly.

How do you use a finishing strip in vinyl siding.

The trim you choose can turn an average doorway into an inviting entry. Start fastening vertical siding and corner posts in the top of the uppermost slots to hold them in position. While it may do the job it may not give you the look you hoped to achieve. Be sure the top and bottom click into place.

Place all other fasteners in the center of the slots. Vinyl siding starter strips. This is where the new siding will begin. If you re having difficulty just pressing them in you may need to pull the channel lip back with a pry bar or locking tool to get the siding panels to fit.

Family handyman use the wider starter strip the bottom of the starter strip the part the bottom panel hooks on to should be at least 1 in. It protects the sheathing from rain snow and pests. Start fastening in the center of the panel and work toward the ends. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows.

Attach j channel trim strips around windows and doors and along the eaves. Nail the starter strip to the siding aligning the top of the strip with the chalk line. For most of the house this method works wonderfully except for the top row. You can do this by pressing the soffit pieces into the channel bending them to fit if necessary vinyl siding is quite flexible.

Nail vertical vinyl corners to the corners of the house making sure they are plumb. Snap a level chalk line for the first starter strip at the base of the wall no less than 8 inches above ground level after determining the lowest corner of the house. Usually a wood 1 x 2 25 4mm x 50 8mm strip used to even a surface in preparation for installing vinyl siding. To overlap the ends of two siding panels or accessory pieces to allow for expansion and contraction of the vinyl product.

Push the top of the vinyl siding with the tabs into the utility trim just enough to hold the edge and push the bottom against the second to last piece of siding. To fur a surface means to apply these strips. Below the top of the foundation but the lower the vinyl siding is installed the better. Push up gently until you hear a click.

The entire structure of vinyl siding is based on overlapping sections with the attachment point on each row of siding covered by the one above it. If you have not specified the type of door and window trim you prefer with your contractor you may end up with the basica universal j channel the trim most installers use as a default. Pop a level chalk line for the starter strip an inch or two above the bottom of the siding.