Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip.
How do you replace a piece of missing vinyl siding.
Use a cat s paw or other small pry bar to pull the nails from the course you need to remove.
Cut piece of faded siding from an inconspicuous spot to replace the damaged section.
In this video this old house general contractor tom silva explains how to repair vinyl siding.
Work your hand into a seam between pieces then release the siding from the nailing strip.
Use framing square and utility knife to cut through face of siding.
Hold the removed segment up to a spare piece of vinyl siding.
It ll better match the house than brand new siding.
Insert the siding removal tool where the panels overlap and pull down and out.
Once all the nails are removed from the adjoining board the damaged one should just pull out.
You may want to wait for a warm day when the siding will be softer and more pliable.
Pull the nails holding the damaged siding and remove the damaged piece.
Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it.
Score down the damaged lap siding with a utility knife.
First remove the corner piece then slide the zip tool under the siding and loosen it up.
Be careful because older siding can become brittle.
Measure and mark a point 2 inches 5 1 cm away from each side of the removed segment.
Push the new piece into the nailing strip of the course below.
15 minute vinyl siding repair with a zip tool.
Cut a vinyl patch 4 inches 10 cm wider than the removed segment.
Remove the nails in the corner cap.
Remove the nails on the lap board then use the claw of the hammer to split the board down the center image 1.
Push the upper piece.
Pull the piece of vinyl siding downward to disengage it from the course below it.
Hgtv expert henry harrison shows how you can reattach it using a vinyl siding removal tool also known as a zip tool.
Insert the zip tool into the hook at the bottom of the piece of vinyl above the new piece.
Cut the spare piece of vinyl along the marks using straight tin snips.
Pull the tool downward to bring the hook over the top of the new piece of siding.