Once the zip tool is latched onto the lip pull the siding piece downward and slide the tool horizontally across the entire length of the panel unhooking the lip.
How do i remove a piece of vinyl siding.
Use the zip tool to release the buttlock at the top and bottom of the piece you want to remove.
Go to the end of that row either near a corner piece or a j channel.
Use a zip tool to disconnect two pieces of siding.
First you nail up the new piece driving nails through the slots in the nail hem then you connect the buttlocks with the zip tool.
With the other use the claw end of a hammer to pry up the nails holding the damaged piece of vinyl to the wall.
Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip.
Zip tools disconnect a higher piece from a lower piece.
Locate the vinyl siding piece above the piece you need to replace.
Insert the tip of the zip tool into the.
Insert the siding removal tool where the panels overlap and pull down and out.
Use a cat s paw or other small pry bar to pull the nails from the course you need to remove.
Repeat until you re at the ground and then remove the surrounding trim.
Start by lifting an overlapped piece of vinyl on the top row.
To remove a piece at your eye level slide the zip tool under the piece above that one.
Look for a horizontal seam between two courses of vinyl siding.
Remove the nails one at a time to disconnect the entire length of vinyl.
Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it.
Hold the loose undamaged piece of vinyl up and out of the way with one hand.
The vinyl siding zip tool will save you loads of time.
How to remove and replace a section of vinyl siding.
How to remove small pieces of vinyl siding.
Reveal the nails anchoring a piece to the wall by sticking the zip tool under the bottom of the piece above it.
Look under the siding piece you just located for a short flat notch.