On the 1 x 12 arms where you placed the marks in the previous step use the hole saw to bore straight through.
How do i make a roof rake.
Rake plates of one by 2 inches often cover the exposed top edge of the liner when there is also a ledge at the end of the gable.
Use the drill to make a hole in the aluminum pole using the bracket holes as a guide.
Use your clamp to attach the two 4 inch brackets to one end of the aluminum pole positioning one angled bracket on each side.
Insert your 2 1 2 inch.
Without a real roof rake i was forced into searching the garage to craft something homemade.
Apply some pvc glue to the inside of the arms.
I have to say it worked great i used the metal part face down not the rubber part.
The roof rake plates are installed in different widths depending on the surface being covered.
Drill straight through the aluminum handle through one bracket hole to the hole on the other side using your.
How to make a roof rake step 1.
When the snow started to pile up on handyman bill.
Attach the two 4 inch angle brackets to the end of your aluminum pole.
Make sure the holes on the brackets are lined up and are angled at 90 degrees.
Begin by cutting two 12 sections from one on the 1 x 10 pvc pipes.
Position a bracket on each side of the.
I used the driveway sealer squeegee and an extension pole to work as a snow roof rake.
An added bonus was that i could use one end of.
Here s what i came up with.