Low air pressure can cause these symptoms.
Hitachi roofing nailer air pressure.
From its birth hitachi has.
Packed with fasten edge technology an industry leading feature set this nailer can take on any roofing job.
The gun doesn t work at all.
Technology is the common thread behind the hitachi brand.
Metabo hpt was hitachi power tools 1 75 gauge 15 degree corded roofing pneumatic nailer.
The air pressure used for this is 100 psi to 90 psi.
Step 3 check for a jammed nail in the shooting area if the nailer operates but does not shoot nails.
Burying the roofing nail too deep or not deep enough can affect the life of the roof so it is very important to dial the pressure in correctly.
Adjusting air pressure english adjusting air pressure 2 adjust the air pressure to 70 psi 4 9 bar 5 kgf cm connect the air hose.
For pricing and availability.
Continuous use tools need more air volume and therefore have a higher cfm requirement.
Most nailers are ran between about 100 psi and 120 psi.
Correct air pressure know and check the nailer s operating pressure which should be found in the owner s manual.
Pneumatic power is the most common power source used by roofing nailers.
If the manual is not available they are usually available to view online on the nailer manufacturer s website.
Make sure to look at the cfm air volume and psi air pressure of the air compressor to be compatible with your nailer.
Ridgid introduces the 15 degree 1 3 4 in.
Metal housing for durability.
Metabo hpt was hitachi power tools metabo hpt 2 5 in 15 gauge cordless finish nailer.
Reduce the air pressure on the air compressor to between 70 and 120 psi pounds per square inch if the nails are driven too deep into the material.
Be sure that the correct nails are used with the nailer.
If a lubricator is not available supply 5 10 drops of hitachi pneumatic tool lubricant into the air plug on the push lever and trigger must move the nailer twice a day.
A constantly spinning sander might have a cfm requirement of 8 8 cfm 90 psi for example while a nail gun which requires single bursts of air might have a lower cfm rating of 2 8.
The air inlet is 3 8 inch and the ideal operating air pressure is 70 120 psi.
Don t exceed the maximum recommended air pressure.
Do not load any nails in the nailer.
This roofing nailer is a perfect combination of power weight and speed.
Hitachi nv45ab2 works with the air pressure of 70 to 120 psi.
The large carbide inserts on the nose provide durability and performance during operation.
The nv45ab2 has a quick driving feature that provides maximum efficiency when nailing large areas by allowing the nailer to shoot each time the nose touches the work surface.
A pneumatic stapler might just need 0 3 cfm while a framing nailer may require 2 2 cfm.